Oreck Quest Pro Canister FC1000 - Brushroll and Belt Maintenance

15
• Wash lter in warm water or replace it with a new one.
The lter must be completely dry before it is put back
into the vacuum.
DO NOT operate without a motor lter in place.
Replace the Hepa Media Filter
• The Hepa Media Filter aids in the ltration process to
return clean air to the room.
• To remove this lter, open bag lid, unsnap the lter
latch and pull the lter out. Replace with a new lter.
NOTE: The lter should be replaced annually.
REPLACING THE POWER NOZZLE BELT
• The belt in your power nozzle drives the brushroll. It
has been designed specically for use in this vacuum
and is important for effective operation.
• The belt should be checked on a regular basis to
ensure it is in good condition. Replace the belt if it is
stretched, cut or broken.
• Use the following procedure to check or replace the belt.
Remove Nozzle Hood Screws
• Disconnect power nozzle from extension wand.
• To remove hood, turn nozzle over and unscrew the 7
recessed phillips head screws (A).
Maintenance
- continued