EasyManuals Logo

Oreck SPEED SWEEP TEK 100 User Manual

Oreck SPEED SWEEP TEK 100
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Safety Warning
1. Be sure to use the product in compliance with the contents of this manual, and use
approved Oreck replacement parts.
2. After unpacking, make sure that the appliance is intact with no visible signs of damage
caused during shipping. If damage has occurred, do not use this product. Take it to
an authorized Oreck Clean Home Center for service. All packing materials (plastic
wrapping, cardboard box, etc) are potentially dangerous and must be kept out of
children’s reach.
3. Do not leave this product unattended when power is on.
4. Be sure to keep the air intake free and clear of any large debris which can cause a
blockage in the air ow, impacting overall performance.
5. Be sure to keep the air exhaust outlet free and clear to prevent the risk of the motor
burning out.
6. Do not use this product on uneven oors or surfaces and be careful when cleaning
stairs to prevent this unit from falling down.
7. Keep away from heat sources (such as central heating air vents, ovens, etc.) to prevent
the distortion of plastic parts.
8. Before using this product, please remove any large or sharp matters on the oor in
order to avoid damaging internal parts including the lter and motor.
9. Do not try to pick up wet or other liquid items, which will result in damage to the
motor.
10. Keep any loose clothing items away from moving brush roll.
11. The charger is uniquely designed for the rechargeable Ni-MH battery, rating:
Input: 120V, 60 Hz, 50mA
Output: 9V DC, 280Ma
Class: 2
12. After inserting the plug of the charger into the electrical socket, the power light (green)
will illuminate. Insert the rechargeable battery module, this will cause the charge
indicator light (red) to blink. Battery will be fully charged after 8 hours when red light
is solid (not blinking).
13. Once the battery is fully charged, it can be placed into the unit. Before doing so, be
sure to switch the power “OFF” to prevent any possible electrical charge.
14. The brush roll should be cleaned on a regular basis in order to maintain optimal
performance.
15. The lter inside the dirt cup can simply be washed in warm soapy water and can be
used again after drying.
16. Its suggested to change the lter every 6-12 months, however this may vary depending
upon use.
2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oreck SPEED SWEEP TEK 100 and is the answer not in the manual?

Oreck SPEED SWEEP TEK 100 Specifications

General IconGeneral
BrandOreck
ModelSPEED SWEEP TEK 100
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals