5
E N G L I S H
6. REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a
month—even if it is not full! The collected dust in the dust
filter can cause odor, attract moisture, act as a breeding
area and can affect the efficiency of the cleaner.
8. ! !&run the vacuum cleaner over the cord. The
revolving brush could damage the cord.
9. Use caution when vacuuming over area rug edges and
fringe.
5?<;?-.81"-<1>58@1>A?@-3?
Disposable paper filter dust bags play a very important role in
the efficiency of your ORECK vacuum cleaner. The purpose of
the filter bag is to trap dirt, but at the same time it must be
porous enough to allow air to pass through. If the filter bag
becomes clogged, no air can pass through the cleaner and
cleaning cannot take place, regardless of the cleaner’s power.
To keep your cleaner operating at maximum efficiency, change
the dust bag frequently. DO NOT FILL ABOVE THE LINE
INDICATED ON THE DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
88<-<1>0A?@.-3?->1:;@@41?-91+;A>!$
05?<;?-.810A?@.-3?4-B1.11:01?53:10@;.1A?10C5@4
@41!$/81-:1>'?5:3.-3?;@41>@4-:31:A5:1!$
05?<;?-.81.-3?C588-221/@@41/81-:5:3-.585@E;2E;A>
/81-:1>-:0/;A80/-A?10-9-31@;5@
&4118@
The belt on your vacuum cleaner controls the speed of the
revolving brush and is very important for the effective operation
of the cleaner. If the belt becomes stretched or cut, it will cause
the revolving brush to stop completely or slow down. See
instructions in the manual for replacing belt.
:1D@>-.18@5??@;>105:@41.-?1<8-@1;2E;A>/81-:1>
)41:.AE5:3>1<8-/191:@.18@?A?1! +!$31:A5:1
.18@?18@?;@41>@4-:!$ .18@?C588:;@;<1>-@1@41
>1B;8B5:3.>A?4/;>>1/@8E-:09-E/>1-@1A:0A1?@>1??
C45/4C588/-A?10-9-31@;@419;@;>-:0.>A?4.1->5:3?
'?5:3.18@?;@41>@4-:!$.18@?C588B;50@41C->>-:@E
A.>5/-@5;:
The vacuum cleaner motor bearings are factory lubricated and
sealed. Further lubrication is not required.
1:1>-881-:1>->1
At least once a month, check for
and remove excessive lint, string
or hair from the revolving brush.
Wipe the outside of the cleaner
with a damp cloth. Also, clean
the connector deflector assembly
area, base of cleaner and fan
housing area. If there is dust in
the outer bag, vacuum it or
shake it out.
A little preventative maintenance
will keep your cleaner looking
new and will ensure continued
cleaning effectiveness.
'&! V);;08;;>?%;2@(5:E8?<4-8@&5811@/
8;;>%A>2-/1?-:0";85?4108;;>5:5?41?
Use floor and floor finish manufacturer’s recommended methods
of cleaning. The metal strip on the base of the cleaner could be
damaged if used on concrete or abrasive surfaces, and,
therefore, cause damage to wood floors, soft (vinyl, asphalt tile,
etc.) floor surfaces and polished floor finishes. The roller brush
may also scuff very soft finishes. Do not operate the unit while
To Replace Filter
Dust Bag
%&&!
1. Hook bottom of bag collar
opening under lip “B” of
connector assembly. Pull up
on bag collar and snap over
lip “A” of connector.
2. Press on edges of bag collar
to insure bag is completely
installed.
"!$& & Check to make
sure bag collar is behind lips
“A” and “B”. If it is not, dust
will leak into outer bag.
When filter bag is in place,
close outer bag with zipper
fastener.
WARNING: Unplug cord from
electrical outlet before servicing.
A
B
in the upright and locked position. Do not let the unit run while
in any one stationary position for any period of time. Keep the
unit moving while in operation.
To Next Page
Loading...
Need help?
General
