GB
6
LCD screen. The main unit will automatically update its readings
approximately every 30-seconds.
CHANNEL
M
D
AM
C
P
M
E
If no signals are received, blanks "----" will be displayed and the
kinetic wave icon will show " ". Press [CHANNEL] and
[MEMORY] at the same time for about 30-seconds to trigger a
signal search. This will synchronize the transmission and recep-
tion between the remote sensor and main unit.
REMOTE & INDOOR TEMPERATURES
The indoor temperature is shown on the second line of the LCD
screen.
The temperature data received from the remote sensor is displayed
on the top line of the LCD screen. Press [CHANNEL] to sequence
through the channels. The temperature displayed will be the data
for that specific channel and remote sensor.
A kinetic wave will be displayed below the channel number
indicating the quality of signal reception from that particular
channel. See “Reading the Kinetic Wave Display.”
If the main unit does not receive data from the remote sensor after
two minutes, blanks “---” will be displayed for that channel until
future data is successfully received. Verify that the remote sensor
is still in position and that the low battery icon is not displayed.
Press [CHANNEL] and [MEMORY] at the same time for about
30-seconds to trigger a signal search between the main unit and
the remote sensor.
Should the temperature go above or fall below the maximum and
minimum temperature measuring ranges of either the main unit or
the remote sensor, the LCD screen will show “HHH” or “LLL.”
See “Specifications” for Temperature Measuring Range.
READING THE KINETIC WAVE DISPLAY
The kinetic wave icons shows the signal receiving status of the
main unit. There are three different status icons:
MAXIMUM & MINIMUM TEMPERATURES
The unit is in searching mode.
Temperature readings are
securely registered.
No signals.
To Next Page
Loading...
Need help?
General
