Oregon Scientific WMR100 - Wind Sensor; Rain Gauge; Getting Started; Set up Remote Wind Sensor

4
EN
Humidity / Dew Point Area
1. Dew
point level - Temperature is showing
2. HI / LO humidity and Dew Point alarms are set
3. Comfort levels
4. Humidity trend
5. MAX / MIN humidity
6. Humidity reading
WIND SENSOR
1. Wind vane measuring the wind speed
2. Wind direction sensor
3. Battery compartment
4.
RESET
hole
5. North indicator
6. Plastic sleeve protecting the batteries
RAIN GAUGE
Base and funnel
1. Rain gauge
2. Battery compartment
3.
RESET
button
Tipping bucket rain gauge
1. Funnel
2. Level indicator
GETTING STARTED
SET UP REMOTE WIND SENSOR
The wind sensor can take 3 readings:
• The wind speed and directions
• The outdoor temperature (Channel 1 only)
• The outdoor relative humidity (Channel 1 only)
The sensor is battery operated and is capable of
transmitting data to the base station wirelessly within an
approximate operating range of 100 meters (328 feet).
NOTE
For best results, ensure that the wind direction
indicator on the wind sensor points to the North to
enable an accurate reading. The sensor also should
be positioned in an open area away from trees or other
obstructions.
To set
up the wind sensor main body on the steel
pole:
1. Assemble the wind direction pointer on the top of the
wind sensor.
2. Use the screw (Type B) to fi x.
3. Assemble the wind vanes on the top of the wind
pointer.
4. Use the screw (Type B) to fi x.
5. Hold the wind sensor upright and rotate the
protective sleeve to the left to unlock.
1
2
3
4
5
6
1
2
5
6
3
4
1
2
3
1
2
1
2
3
4
WMR100_EN_86L4515-017.indd 4 6/15/06 4:24:53 PM