Oregon Scientific WMR86NX - GETTING STARTED; SET UP REMOTE WIND SENSOR; SET UP REMOTE TEMPERATURE; HUMIDITY SENSOR; SET UP RAIN GAUGE

4
EN
C
 
 
OUTDOOR TEMPERATURE / HUMIDITY
SENSOR
 
 RESET hole
 °C / °F: Select temperature unit
 CHANNEL switch
 
GETTING STARTED
NOTE 

NOTE       
consumer grade lithium batteries in temperatures below

SET UP REMOTE WIND SENSOR
The wind sensor takes wind speed and direction


data to the base station wirelessly within an approximate

To insert batteries:
1
2
      

 
RESET after each

SET UP REMOTE TEMPERATURE / HUMIDITY
SENSOR

To set up the remote sensor:
 
    
       

 
  RESET
 
SET UP RAIN GAUGE

The sensor can remotely transmit data to the base

To set up the rain gauge:
 

         
RESET after each battery

 
SET UP BASE STATION
NOTE 

 
1
5
2
3
4
CF
P/N: 300102839-00004-10 REV1
5/91