PROGRAMMING “SAME” COUNTY
SAME county codes are required to receive weather
and environmental information, and need to be entered
into the WR113. Up to 6 specifi c SAME codes can be
entered into 6 display fi elds.
The system can only alert the user to weather
warning information after SAME county-code
information has been entered and enabled.
When the county code display is fi rst entered, the user
see a display fi eld providing the option of selecting
all (ALL) or none [----] of the county codes. Selecting
ALL will set the unit so all of the warnings and weather
messages from a specifi ed channel can be received.
If none [----] is selected the unit will receive warning or
weather information only from the specifi c regions that
have been specifi ed with respective county codes.
It is recommended to select a SAME code fi eld
between (1-6) and then enter a specifi c code for that
fi eld. Selecting ALL will result in the unit giving warnings
for regions that are not relevant to the user. These
regions are quite large and can encompass about 5,000
6 display fi elds permit up to 6 county codes to be
entered. The user can select less than 6 codes by
leaving the unused display fi elds empty.
As mentioned in the section “Finding local NWR
channels and County codes”, a toll-free phone number
or Internet website are available to locate county code
DESCRIPTION OF SPECIFIC AREA MESSAGE
A SAME code is broken into 6 fi elds of numbers.
County code for Cochise County, Arizona
WR113_EN_M REV10.indd 10 3/30/07 10:15:19 AM
To Next Page
Loading...
