EasyManua.ls Logo

Oregon Scientific WR113 - How to Set the Alarms; Setting the Alarm

Oregon Scientific WR113
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
14
10. Press
MODE
or wait 9 seconds to exit the Clock-
Setting Mode and return to the time display.
HOW TO SET THE ALARMS
The
WR113
has 2 alarms (
Alarm
1 and
Alarm
2). They
can be used together or independently. The Alarm icons
are only displayed when
Alarm
1 or
Alarm
2 are active.
No icon(s) indicate that the alarm(s) have not been set.
Remember: From the Clock-Display mode, press MODE
to enter Calendar-Display and then again to set Alarm 1.
Press MODE once more to set Alarm 2.
Setting the Alarm:
1. With the clock displayed, press
MODE until alarm
(1 or 2) display is entered.
NOTE
The last set time of the alarm will be displayed.
If you have not set the alarm before, or if the alarm has
been disabled, the time will be displayed as [----].
2.
Press and hold
MODE
for 2 seconds.
Remember:
At any stage of the setting sequence, if no
entry
is made after 9 seconds, the unit will automatically
return to the Clock-Display mode.
3.
To enter the hour, press
or
until the desired
hour has been selected.
Remember:
Pressing and holding
or
will advance
digits in rapid sequence.
4. When the desired hour is reached, press
MODE
to
advance select minutes. Press
or
to change
values.
5. After selecting the minutes, press
MODE
or wait
9 seconds to exit Alarm-Setting Mode and return to
Clock-Display mode. The alarm ON icon (
) for
the chosen alarm, will be shown to indicate that the
alarm is set and will sound at the set time.
When an alarm goes off, it will sound for 1 minute, the
EL backlight will activate. Alarms 1 and 2 are identifi ed
by different sounds: Alarm 1 has 2 short bursts of sound
followed by a pause which then repeats. Alarm 2 has 4
short bursts of sound followed by a pause, which then
repeats. Unless disabled, the alarms will sound for a
total of 1 minute before automatically turning off.
DISABLING AN ALARM
When disabled, the respective alarm icon will not be
displayed. A disabled alarm display is indicated by
blanks [----].
WR113_EN_M REV10.indd 14 3/30/07 10:15:23 AM

Other manuals for Oregon Scientific WR113

Related product manuals