Oregon Scientific WR113 - Temperature and Ice Alert; Freeze Alert

EN
12
To select to receive all warnings or only warnings
from specifi ed localities:
1. Press
COUNTY
to enter the county-code display
COUNTY to enter the county-code display COUNTY
from any clock display mode.
2. Press
or
to switch between receiving all (ALL)
warnings or only warnings from specifi ed local
areas [----].
NOTE
If (1-6) [----] (specifi ed local area) is selected,
local county codes need to be programmed into the
unit.
To enter the appropriate county code:
1. Press
COUNTY
to enter the county-code display
COUNTY to enter the county-code display COUNTY
from clock-display mode.
2. Press
COUNTY
to bypass the county-code fi eld 0
COUNTY to bypass the county-code fi eld 0 COUNTY
and advance to county code fi eld 1.
3. To enter the county-code in this fi eld, press and hold
COUNTY
for 2 seconds. The extreme left county-
COUNTY for 2 seconds. The extreme left county-COUNTY
code digit will fl ash.
4. To enter the fi rst county-code digit, press
or
.
Remember:
This part of the code subdivides a county
into localized sub-sections. If the county code has not
been subdivided into smaller sub-sections, select (0) in
the far left column.
5. Enter the remaining 5 digits by following the same
process. Press
COUNTY
followed by
or
.
6. When fi nished, press
COUNTY
to advance to the
COUNTY to advance to the COUNTY
next county-code fi eld, or wait 9 seconds to
automatically return to clock-display mode.
RADIO VOLUME
Before you can set the volume, the radio needs to be in
NOAA on mode.
To set the radio volume:
1. In Clock-Display Mode, with the radio set to NOAA
on, press
or
to adjust the volume.
TEMPERATURE AND ICE ALERT
WR113 displays the temperature in degrees Fahrenheit
(°F).
FREEZE ALERT
If the temperature falls between 37°F to 28°F,
fl ashes to
warn you that the temperature is approaching freezing.
NOTE
The warning will automatically stop if the
temperature goes outside the ice-alert range.
WR113_EN_M REV10.indd 12 3/30/07 10:15:21 AM