To disable alarm (1 or 2):
to enter alarm-1 or alarm-2 display
When an alarm is activated, the alarm time
will be displayed in the alarm display. In the Clock-
Display mode, the respective alarm-on icon will appear
indicating that alarm1, 2 (or both) is set.
When disabled, the respective alarm icon will not be
displayed. The display will show blanks [----].
To enable alarm (1 or 2):
to enter alarm 1 or alarm 2 display followed
The respective alarm-on icon will appear
] alarm time will be replaced with the alarm
An alarm can be disabled but remain set so that it will
activate at the same time the following day.
is activating, press any button
). The alarm will be stopped and
will activate again at the same time the next day.
When either alarm 1 or 2 sounds, pressing
will stop the alarm for 8 minutes before it sounds again.
The EL back light casts a blue light evenly across
the LCD making information easy to read in low light
conditions. To activate the backlight, press
To activate / deactivate key lock:
EMERGENCY ALERT SYSTEM (EAS)
The Emergency Alert System (EAS) uses the latest
technology to allow local authorities to broadcast
important emergency information to specifi c areas.
The Emergency Alert system was originally designed
as a communications link between the President and
the general public during times of emergency. The
EAS communication link is instant and can target the
State, National, and Local Area levels. The EAS and
NWS share the same digital signal used on the National
Oceanic and Atmospheric Administration’s Weather
Radio (NWR). Ultimately, the purpose of EAS is to
deliver emergency alert information to those who need
WR113_EN_M REV10.indd 15 3/30/07 10:15:23 AM
To Next Page
Loading...
