Oricom secure55 User Manual

8
Baby Unit
1. Plug the remaining power adaptor into the
socket on the baby unit labelled DC6V 500mA.
2. Thread the cable through the cable clips on
the rear of the unit to hold the charger cable in
place.
3. Plug the end of the charger cable into the mains
power and switch on.
4. To turn on the baby unit, press and hold the
power button. The green indicator lamp will
flashuntiltheparentunitisdetected.
Starting Up
1. Power on the parent and baby units by pressing
and holding the power button .
2. Thegreenindicatorlampwillflashonbothunits
whilst the connection is being established.
3. Once the parent unit and the baby unit are
linked, the indicator lamp will become a solid
green light.
NOTE: The indicator lamp on the parent unit will
continuetoflashredwhilstitisoncharge,afterthe
link has been established.
If the link is broken:
• Check that the mains power is plugged in and
switched on at the baby unit
• Check that both units are powered on
• Check that the batteries are charged in the parent
unit
• Check that the parent and baby units are within
range of each other (in ideal conditions the range is
up to 300 metres outdoors and 50 metres indoors)
SETTING Up
Thelinkconfirmationbetweenthetwounitsisvitalfor
use so they can communicate. If the link between the
units is broken at any time, the indicator lamps will
flashgreenontheparentandbabyunitsastheytryto
search for each other. After 30 seconds, if the link is
still broken, an alert tone will sound on the parent unit
until the link is re-established.
IMPORTANT

Oricom secure55 Specifications

General

Brand	Oricom
Model	secure55
Category	Baby Monitor
Language	English