Oricom UHF400R - Page 7

7
Rear Microphone Socket
The UHF400R has been tted with an additional microphone socket on the
rear panel of the radio. To use this socket you must purchase the extension
microphone cable.
The socket has been covered with a label to stop dust and other partials
entering the radio. When you need to use this socket to extend the microphone
cable remove the label and t the extension microphone cable RJ45 plug to the
recessed socket and seat the dust cover in the aperture around the cable.
The other end of the microphone cable has a round dust cover tted please
remove this cover and t over the front panel microphone socket.
When using the extension
cable and microphone the
front panel microphone
socket should not be used.
The extension cable is
supplied with a socket
mounting bracket, push the
round microphone extension
socket through the large
hole in the bracket and then
secure in place with the
microphone plug.
Controls and Connectors
Removable label