12
The LED Indicator
Connect the socket of the wall adaptor to a mains power outlet
and insert the jack of the wall adaptor
into the desktop charger plug. It takes
approximately 3 hours to fully recharge.
Place your transceiver into the cradle of
the desktop charger. The RED LED on the
charger will light up.
When charging is complete take the
transceiver out of the cradle and detach
the socket of the wall adaptor from the
mains.
The red LED on the mains charger pod
will change to green when charging is
complete. It will take approximately 3 hours
to fully charge the battery with the radio
turned off.
The Belt Clip
1. Place the belt clip into the slot on the back of the radio.
2. Then slide it down.
3. You will hear a click. The belt clip is rmly installed.
Do not transmit when the UHF5500
is in the charger pod.
Installation
To Next Page
Loading...
Need help?
General
