15
Power On/Off
To turn on the transceiver, turn the volume knob clockwise until you
hear a click.
To turn off the transceiver, turn the volume knob fully counter-
clockwise.
Volume
Rotate the Volume knob until you reach the desired level.
Channel Selection
Press the channel up or down buttons until you select the desired
channel.
Transmittion and Reception
To transmit keep the PTT button rmly pressed and the red LED will
illuminate.
Wait for approximately 1 second and then speak in the direction of the
microphone, and hold the device at a distance of about 5cm from your
mouth.
When you have nished, release the PTT.
When the radio is in reception mode you will automatically receive
communications and the green LED will illuminate.
MON(Monitor) Function
The Monitor button is used for temporarily opening the squelch,
in order to listen to signals that are too weak to keep the squelch
permanently opened.
For brief listening, press Monitor breiy and if you want continuous
listening, Squelch off, press and hold for 2 sec.
Press and hold again to turn Squelch back on.
Operations
To Next Page
Loading...
Need help?
General
