To Next PageTo Next PageWhat to do if my Oriental motor Engine fails to turn on?
If your Oriental motor Engine isn't turning on, ensure that both the START/STOP and RUN/BRAKE inputs are set to the ON position. Additionally, the internal potentiometer might need adjustment; try turning it slightly clockwise, as the speed is set to 0 r/min at the factory.
Why is my Oriental motor Engine running in the wrong direction?
The Oriental motor Engine might be running in the opposite direction due to a few reasons. First, check the CW/CCW input; the motor runs clockwise (CW) when this input is ON and counter-clockwise (CCW) when it's OFF. Ensure the connection isn't faulty. Also, if you're using specific speed reduction ratios (30:1, 50:1, or 100:1 with a combination type parallel shaft gearhead, or 20:1 and 30:1 with a geared type), the drive direction will be opposite; in this case, reverse the CW/CCW input operation.
How to fix an Oriental motor Engine that won't stop immediately?
If your Oriental motor Engine doesn't stop immediately, try stopping the motor by using the RUN/BRAKE input instead of the START/STOP input. It's also possible that the load inertia is too high; try increasing the frictional load or reducing the load inertia. Finally, check the acceleration/deceleration time potentiometer to ensure the deceleration time isn't set too long.
What to do if Oriental motor Engine does not run?
If your Oriental motor Engine isn't running, ensure that the motor (gearhead) output shaft and the load shaft are properly aligned and connected. Also, check for any noise interference by running only the motor, driver, and external potentiometer. If noise is present, take measures such as separating the motor from the noise source, reconnecting the wiring, using a shielded cable, or installing a ferrite core.
General| Brand | Oriental motor |
|---|---|
| Model | BLHM230KC-GFS |
| Category | Engine |
| Language | English |
Covers general warnings, installation, and connection safety.
Safety measures for operation, repair, disassembly, handling, and transportation.
Procedure to check supplied items and verify product models upon receipt.
Identifies names and functions of individual driver components.
Specifies suitable environmental conditions for motor and driver installation.
Instructions for mounting geared and parallel shaft gearhead types.
Tables specifying allowable overhung and thrust loads for different models.
Methods for compliant installation and wiring for EMC Directive.
Details on connecting I/O signals for specific BLH models.
Overview of input signals like START/STOP, RUN/BRAKE, and output signals.
Steps to reset the alarm after a protective function is triggered.
How to adjust acceleration and deceleration times using the potentiometer.
Lists protection functions, LED flash counts, and their causes.
Common causes and solutions when the motor does not turn.
Troubleshooting for incorrect rotation, vibration, and slow stopping.
