Oriental motor BLM Series - Connection Procedures; Connecting the Motor and Driver; Connection Cable Outlet Directions; Connector Attachment and Securing

6
Connection
■
Connecting the motor and driver
Connect the motor and driver using the connection cable (sold separately).
There are three types of connection cables which cable outlet directions are
dierent.
Cable outlet in opposite
to output shaft direction
Cable outlet in output
shaft direction
[ Cable outlet direction
]
Cable outlet in
vertical direction
Check the operating manual
of the driver for how to
ground.
Connection cable
Motor
To driver
Cable outlet in output shaft direction
CC_____
F
CC_____B CC_____V
Note
Do not apply a strong force on the locking lever of the connector for
motor connection. Applying a strong force on the locking lever may
cause damage.
Locking leve
r
■
Connection procedures of the motor and connection cable
The following example explains using the connection cable of "cable outlet in
output shaft direction."
1
Remove
2
Attach
The connector cannot be inserted
if the locking lever is turned down.
3
Secure
Be sure to turn down
the locking lever till
the position shown
in the gure.
Secure the connector by turning
down the locking lever completely.
Check the cable outlet direction and insert the connector securely.
Secure the cable with the locking lever so that the cable does not
come o.
Locking lever
Position of locking lever
Connector cap
Note
Do not lift up the product by
holding the connection cable.
Doing so may cause damage to
the product.
■
Detaching the connection cable
Turn up the locking lever to detach the cable.
The connection cable for relay can be used by connecting up to 2 pieces.
Check the operating manual included with the driver.