Page 2
Introduction
Thank you for choosing the Enigma SED from Origin Storage to secure your data.
Incorporating the latest 256 Bit AES hardware encrypted 2.5” hard drives from Toshiba; the Enigma SED
solution provides permanent full disk encryption on the fly, which means no speed degradation when
reading and writing data. With each Enigma SED conforming to the latest Trusted Computing Group OPAL
Self Encrypting Drive standard you can be sure your data is protected to the highest levels.
We advise you to read this manual carefully before using this product to ensure that you setup and configure
it correctly.
Box Contents
Please check the contents of the box; the following items should be included:
• Enigma SED Hardware Encrypted 2.5” Drive
• Appropriate Fitting Kit (Attached To Enigma Drive Unless “Bare Drive Only” Kit)
• SATA to eSATA Data Transfer Cable
• eSATA to USB Adapter
• CD-Rom with application software and manuals
• Software License Code(s)
• “Protected By Enigma” Sticker
• Warranty Registration Card
System Requirements
Hardware Requirements:
In order to use the Enigma SED your system must meet the following requirements:
• Intel Pentium III / AMS Duron 700 Mhz or higher
• 128MB RAM or higher
• CD-Rom or DVD-Rom drive for installing software
• Available USB 2.0 or eSATA/USB Combo port
Software Requirements:
• Windows XP Professional with Service Pack 3 or higher
• Windows Vista with Service Pack 1 or higher
• Windows 7
Enigma SED supports both 32 Bit and 64 Bit versions of the above operating systems.
To Next Page
Loading...
General