Page 7
10) Once the setup wizard has finished copying the files click “Close” to complete setup.
11) Close the Acronis True Image HD start menu by clicking the red “X” in the top right corner and exit
the Enigma SED start menu by clicking “Exit” and remove the CD from your CD drive.
Hardware Setup:
In order to clone data from your existing hard drive to your new Enigma SED, you need to use the supplied
Data Transfer Cable to connect the Enigma SED to your computer. Depending on available ports you can use
either a USB port or eSATA/USB Combo port to connect the Data Transfer Cable to your computer. If you
have an eSATA/USB Combo port we would recommend using this connection as it will allow for quicker data
transfer than USB.
Once you have determined the connection type available, follow the relevant instructions below to complete
the hardware setup.
USB Connection
1) Connect the SATA connector on Data Transfer Cable to the SATA connector on the Enigma SED hard
drive.
USB 2.0 Port
eSATA/USB Combo Port
To Next Page
Loading...
General