Page 4
Installation Instructions
The Enigma SED can be installed as an upgrade for your existing hard drive; the following instructions will
guide you through the installation process including how to clone data on your existing hard drive to the
Enigma SED.
There are 3 steps to complete the installation of Enigma SED:
• Step 1 - Clone your existing drive to the Enigma SED drive
• Step 2 - Fit the Enigma SED drive in your computer
• Step 3 - Activate the hardware encryption to secure your data
Step 1 – Cloning Your Drive
Software Installation:
1) Insert the Enigma SED Software & Manual CD into your CD drive. If prompted click “Run
autorun.exe”, followed by “Allow” on the User Account Control dialogue. The Enigma SED start menu
will open.
If the start menu does not appear click on the Windows “Start” button and then select “Run”. Type
“X:\autorun.exe” (without the quotation marks) and replace “X” with the appropriate letter
corresponding to your CD drive. Click “OK” and the Enigma SED start menu should now open.
2) Click “Step 1 - Install Acronis True Image HD” button on the Enigma SED start menu.
3) On the Acronis True Image HD start menu click “Install Acronis True Image HD”.
To Next Page
Loading...