Orion 150 HCCA - Page 14

AMPLIFIER CONFIGURATION DIAGRAM
• Denotes two signal pins that can be connected.
■ ■ • Denotes two signal pins that are internally connected.
24 ,
DVX-2 CONFIGURATION
The Concept 97 1 is equipped with two factory installed DVX-2
crossover modules. The DVX-2 is an extremely flexible crossover mod¬
ule that can perform many different crossover functions. Listed are
the basic functions of the module.
• 12dB/Octave high-pass or low-pass.
• 24dB/Octave high-pass or low-pass (when crossovers are set to
the same frequency).
• 12dB/Octave band pass operation.
• Crossover 1 can independently be routed out the AUX output to
an external amplifier. (Applies only when installed in the module
slots for channels 1 & 2.)
Crossover Call Out
I XVR1 Frequency
XVR1 Svwitch Adjustment Control
Slot B Slot B XVR2 Frequency
XVR1 Switch XVR2 Switch Adjustment Control
25