Orion 150 HCCA - Page 15

Factory Installed Configuration
Loop Output Crossover
• DVX-2 crossover adjustments only affect the amplifier output.
• AUX output is fuli range.
• AUX output is unaffected by internal gain or crossover settings.
Amplifier Crossover selection
The crossover output seiection is controiled by the "SLOT-B" "XVR-
1" and XVR-2" switches. There are three possibie selections:
• Off- for crossover bypass
• HP for high-pass
• LP for low-pass.
NOTE: When both ''XVR-1 " and "XVR-2" are set for high-pass or
low-pass operation, the totai crossover rate of 24 dB/Octave can be
realized when both crossovers are set to exactly the same frequency.
This configuration is best utilized when only a single 12dB/Octave
filter is required for channeis 1 & 2. "XVR " is routed out the AUX
RCA and “XVR-2" is used for channels 1 & 2 in the amplifier.
Jumper Configuration for Loop Output
• XVR 1 can be selected via "Slot A XVR 1 " switch either a high-
pass or low-pass for the AUX output.
• AUX output crossover setting is independent of crossover selec¬
tion for channels 1 & 2.
• AUX output level is affected by gain setting for channels 1 & 2
• Crossover frequency for AUX output is controiied by the "XVR 1
Frequency Adjustment Control"
Slot A XVR1 Frequency
XVR1 Switch Adjustment Control
NOTE: the crossover frequency for loop out¬
put is set by the "XVR-1 Frequency
Adjustment Control" in the DVX-2 module.