Orion 150 HCCA - Page 16

Fine TUning the crossover adjustment
The crossover section is marked at four frequency points for ease
of system adjustment. These points are 45 Hz, 175 Hz , 600 Hz and
5,000 Hz. Specific crossover points can be chosen based on the recom¬
mended operational bandwidth of your speakers.
There are three small dots on the frequency range dial. These dots
represent common used ORION crossover frequencies. These crossover
frequencies are 85 Hz, 2,500 Hz and 3,500 Hz respectively.
175Hz 45Hz
I— 85Hz
When using ORION loudspeakers, minor deviations from the rec¬
ommended frequency ranges can provide superior results depending
on speaker location and vehicle acoustics. Setting crossover frequen¬
cies higher than recommended will not cause damage and may pro¬
vide superior sonic results depending on your system's performance
goals. Refer to your loudspeaker owner's manual for assistance in
choosing the proper crossover frequencies for your system.
WARNING!!! DO NOT set crossover frequencies lower than the
speakers recommended operating range. This can cause driver failure
not covered by manufacture warranty.
28
DIN INPUTS AND PHANTOM
POWER
DIN connection can be used for full range output, power for full
range output, power for external Orion accessory or input from
another Orion amplifier.
CHANNEL 2
IN
29