Orion 150 HCCA - Page 8

2£2 minimum
O.Sfl minimum
• Lowest recommended impedance for Ch 1 & 2 is 2Q per channel
stereo.
• Lowest recommended impedance for Ch 3 & 4 is 0.5Q per chan¬
nel stereo.
• Crossover, output and gain configuration are independently
adjustable between the front and rear channels.
• 2 Channel or 4 Channel input can be used for this configuration.
For source unit fading, used the 4 channel input mode.
• Front and rear outputs can be configured for high-pass, low-
pass, band-pass or full range operation.
• Front and rear outputs can be configured either for stereo or
summed-mono operation for subwoofer applications.
2Q minimum minimum
• channels 1 & 2 are configured for two channel stereo operation.
Lowest recommended impedance is 2Li per channel.
• Channels 3 & 4 are configured for a single channel bridged out¬
put. Lowest recommended impedance is 1f2 bridged mono.
• Crossover, output and gain configuration are independently
adjustable between the front and rear channels.
• 2 Channel or 4 Channel input can be used for this configuration.
For source unit fading, used the 4 channel input mode.