Orion LX Weather Station 29
___________________________________________________________________
Columbia Weather Systems, Inc.
Unpacking the Unit
The sensor transmitter comes in a custom shipping container. Be careful
when removing the device.
CAUTION: Beware of damaging any of the wind transducers located at
the top of the three antennas. Dropping the device can break or damage
the transducers. If the antenna bends or twists, re-aligning can be
difficult or impossible.
Unpack the Orion weather station and verify that all parts are included.
1. Standard system includes:
Orion LX MicroServer
Orion 510 Sensor Transmitter
50 ft sensor cable + additional cable length if ordered
Orion Interface Module
(2) 3-positon terminal blocks
Interface module power supply
User Manual
Two 6-foot RS-232 cable + additional cable length if ordered
2. Weather Display Console (Optional)
Display Console
Power supply
6-foot RS-232 cable + additional cable length if ordered
User manual
3. WeatherMaster 2000 software and user manual (optional)
Inspect all system components for obvious shipping damage (Refer to
“Important Notice: Shipping Damage” in case of damage).
Save the shipping carton and packing material in case the unit needs to
be returned to the factory. If the system does not operate or calibrate
properly, see Section 7: Maintenance and Section 8: Troubleshooting, for
further instructions.
To Next Page
Loading...