Orion LX Weather Station - Section 7: Maintenance; Cleaning and PTU Module Replacement

64 Orion LX Weather Station
____________________________________________________________________
SECTION 7: MAINTENANCE
This chapter contains instructions for the basic maintenance of sensor
transmitter.
Cleaning
To ensure the accuracy of measurement results, the sensor transmitter
should be cleaned when it becomes contaminated. Leaves and other
such particles should be removed from the precipitation sensor and the
transmitter should be cleaned carefully with a soft, lint-free cloth
moistened with mild detergent.
Be extremely careful when cleaning the wind sensors. The sensors
should not be rubbed nor twisted.
Replacing the PTU Module
1. Turn the power off.
2. Loosen the three screws at the bottom of the transmitter.
3. Pull out the top of the transmitter.
4. Release the small white flap and remove the PTU module.
5. Connect a new PTU module (Catalog no. 9581), replace the top
and tighten the three bottom screws.
6. Turn the power on.