Orion SC200 - Page 4

6 APPLE DEVICES (IPHONE/IPAD)
INSTALL IP CAMERA > INSTALL APP > REGISTER AN ACCOUNT > ADD IP
CAMERA TO THE ACCOUNT > READY TO USE
1. Complete system installation according to Section 5.
IMPORTANT: DHCP service must be enabled on the network device.
* For first use, it is recommended that the Apple device is connected via Wi-Fi and
IP camera is connected via network cable to the same local area network.
2. Before installation, ensure your Apple device has 3G/4G or WI-FI internet
connectivity. Go to Apple app store, search, download and install
Plug2view.
3. After successfully installed, Plug2View app logo will be available on your Apple
device screen.
4. Open the Plug2View app.
5.
Register account by pressing Register, fill in the information and then select OK
to complete.
6. Go back to the main page of the
Plug2View app, login using the user name and
password previously registered.
7. After successful login, there are two network sections,
Remote (for remote
connection) and Local (local area network connection).
8. If the Apple device and IP camera is connected as LAN connection, cameras
within the LAN will show up automatically, no configuration or registering
required. IP cameras connected will be listed on the local device list under
Local
section, select the IP camera to view. If the IP camera does not show up on the
Local list page, tap the Refresh button on the top right to refresh
the page.
9. Remote connection allows the camera to be viewed from a remote network. For
Remote option, press the Option key located at the top-right hand corner and
select Add Device to add the IP camera.
PROFESSIONAL
SURVEILLANCE SYSTEM
4
WIRELESS IP CAMERA SC200