10. Fill in the information required:
• Device Alias– (optional) Assign a name to the IP camera.
• Device ID – (required) Refer to label at the bottom of the IP camera
and enter Device ID. (Device ID must be exact match).
• Access Password – (required) Refer to label at the bottom of
the IP camera and enter Access Password.
(Access Password must be exact match).
• Select Done to complete adding
IP camera.
11. If successfully added, the IP camera is
available on the WAN page. Simply
select the IP camera for viewing.
12. When IP camera is connected, Pan/Tilt, Photo Snapshot, Video Record and
Audio Listen functions are enabled:
14. For IP camera settings, press > on the WAN or LAN page
• For WAN connection the IP camera only able to adjust the following settings:
Video settings for setting video quality and SD card settings for SD card
video record setting.
• For LAN connection the IP camera can
adjust the following settings: Ethernet
for configuring network settings, Wi-Fi
for setting up WIFI connection with wireless
router, Video settings for setting video quality,
SD card settings for SD card video record
setting, SD card query for searching recorded
video on SD card and Alarm setting for setting
camera motion detection and user alert email.
* If experiencing video distortions and control
delays, reduce camera resolution, frame rate or
data rate in video settings menu.
* Change password immediately after completing
setup to protect your privacy.
Refer to Section 15 Change Camera Password.
To Next Page
Loading...