10. Fill in the information required:
•
Device Alias
– (optional) Assign a name to the IP camera.
•
Device ID
– (required) Refer to label at the bottom of the IP camera and
enter Device ID. (Device ID must be exact match).
•
Access Password
– (required) Refer to label
at the bottom of the IP camera and enter
Access password. (Access Password must
be exact match).
• Select
Done
to complete adding IP camera.
11. If successfully added, the IP camera is available on the
Remote
list page.
Simply select the IP camera for viewing.
12. When IP camera is connected, Pan/Tilt, Photo Snapshot, Video Record and
Audio Listen functions are enabled:
13. For IP camera settings, press
>
on the
local /remote device
list page:
• For
Remote
connection the IP camera only able to adjust the following settings:
Video settings
for setting video quality and
SD card settings
for SD card video
record setting.
• For Local connection the IP camera can
adjust the following settings:
Wired
setting
for configuring network settings,
Wireless setting
for setting up WIFI
connection with wireless router,
Video setting
for setting video quality
and
SD card setting
for SD card video
record setting.
* If experiencing video distortions and control
delays, reduce camera resolution, frame rate
or data rate in video settings menu.
* Change password immediately after
completing setup to protect your privacy.
Refer to Section 15 Change Camera
Password.
Pan/Tilt
Motion
Control
Photo
Snapshot
Video Record
Audio Listen
To Next Page
Loading...