8 DESKTOP/NOTEBOOK COMPUTER
INSTALL IP CAMERA > INSTALL SOFTWARE CD >
REGISTER AN ACCOUNT > ADD IP CAMERA TO THE
ACCOUNT > READY TO USE
1. Complete system installation according to Section 5.
IMPORTANT: DHCP service must be enabled in the
network device.
* For first use, it is recommended that the desktop/
notebook is connected via network cable/Wi-Fi and IP
camera is connected via network cable to the same local
area network.
2. Insert CD into your computer, install the software
SYSM Monitor.exe or download software from
www.orionlive.com.au
3. First register an account by selecting
Register located
at top-right corner, fill in the information, and then
click
Register to complete.
4. After registering an account, go to
Login located next
to register, login using the user name and password
previously registered.
5. After successful login, there are two network sections,
WAN (for remote connection) and LAN (local area
network connection).
6. If the computer and IP camera is connected as LAN
connection, cameras within the LAN will show up
automatically, no configuration or registering required.
IP cameras connected will be listed on the device list
under
LAN section. Double click the IP camera to view.
If the IP camera does not show up on
LAN, point the
mouse on the device list, right click and then click
Refresh to refresh the page.
7. WAN allows the camera to be viewed from a remote
network. For WAN option, click on
WAN, then right
click on the blank WAN list, go to Add device to add
the IP camera.
8. Fill in the information required:
•
Device Alias – (optional) Assign a name to
the IP camera.
•
Device ID – (required) Refer to label at the bottom of
the IP camera and enter Device ID. (Device ID must
be exact match).
•
Device Access Password – (required) Refer to label
at the bottom of the IP camera and enter Access
Password. (Access Password must be exact match).
• Click
Done to complete adding IP camera.
PROFESSIONAL
SURVEILLANCE SYSTEM
8
WIRELESS IP CAMERA SC200
To Next Page
Loading...