Orla TD36 - Assembly Instructions; Assemble Drum Stand and Base; Connect Drum Module and Pads

Assembly Instruction
Take out the bottom case from the packing
case, insert the drum stand into the bottom
case as shown in the figure and tighten the
T-screw.
Take out the module and three Tom pads
from the packing case, insert them into drum
stand as shown in the figure and tighten the
T-screw.
Take out the cymbal poles from the packing
case, insert them into pad hole as shown in the
figure and tighten the T-screw.
Assemble Crash cymbals as shown in the
figure and tighten the T-screw.
5