Ortur Laser Master 2 - Brief Introduction

2
Brief Introduction
 This Laser Master 2 laser engraver is a desktop laser engraver, not for
industrial use.
 There is a G-sensor on the motherboard for active position protection. If the
machine detects unauthorized movement, the laser beam will stop.
 Laser Beam Safety Guard, if your computer system halted or USB cable
disconnected, led to that the laser engraver stop moving, the laser beam will
stop, to prevent fire.
 Exposure Duration Detection and Limitation, if laser engraver under control,
but user forget to operate and keep the laser beam working, extra safety will
cut off in case motor stopped moving, to prevent fire.
 This laser engraver supports PWM mode.
 The Laser Master 7W is especially good at picture engraving.
 The Laser Master 15W is most cost effective, available for both of engraving
and cutting.
 The Laser Master 20W is higher power and supports a faster engraving and
cutting.