Need help?Do you have a question about the OSCO SWR and is the answer not in the manual?
General| Brand | OSCO |
|---|---|
| Model | SWR |
| Category | Gate Opener |
| Language | English |
Instructions for licensed electricians regarding power connections.
Requirement to install warning signs on gate sides.
Mandates installation of all required safety equipment.
Read manual completely before installation.
Verify supply voltage matches operator voltage.
Lists approved contact/non-contact obstruction detection devices.
Select wire gauge based on model, voltage, HP, and distance.
Do not exceed maximum wire distance based on voltage drop.
Run control wiring in separate conduit from power wiring.
Requires shielded cable for master/slave operator connection.
Emphasizes using copper wire exclusively for wiring.
Specifies pad size (24"x20"x18" deep minimum) and depth.
Use legs if soil conditions may cause shifting.
Describes the 2-inch diameter hole for conduit.
Pedestrian gate requirement and distance from vehicular gate.
Position operator parallel to gate, matching dimensions.
Measure distances for crank extension and link sections.
Rotate arm assembly to convert between right and left hand.
Ensure correct voltage/phase and use disconnect switch.
Calibrates built-in current sensing for obstruction detection.
Reminders about safety, controls placement, and current sensing.
Set light enough for obstruction, high enough for normal operation.
Step-by-step process to adjust close direction current sense.
Step-by-step process to adjust open direction current sense.
Checks for overload, power, and blown fuses.
Checks for slipping, broken chains, or loose setscrews.
Checks for false obstruction signals or timer expiration.
Checks for false signals from detectors or stuck devices.
To Next Page