9. Spin the front wheel and apply the front brake. Do this twice. While holding the
front brake on - tighten caliper bolts. This will centre the caliper and help to give
even wear of the pads and free running of the front wheel.
10. Adjusting rear caliper. Ensure rear wheel is clear of ground and turn by hand
and check brakes are not binding if they are loosen cap screws and adjust. Be
aware that because the wheel can be moved back and forth for chain adjustment
the caliper does also - so make sure it does not rub on the outer diameter of disc.
11. Install the front number plate using the supplied ‘zip-ties’. This attaches to
the handlebars and the forks (picture 7).
7. 8. 20.0, 48v Only 9. 20.0, 48v Only
See page 29 for 36v Wiring
12. Check tire pressure of both tires and confirm they are properly inflated to 20-
40 psi. Light riders can use lower pressures.
13. Unpack batteries from box (shipped separately).
A - 16.0 & 20.0 Light - Install the batteries as indicated page 29
B – 20.0 - Install the batteries as indicated (picture 8 & 9)
It is vital that connections are made correctly. The battery bag should be installed
before connecting the positive (red) and negative (black) leads.
WARNING!
Failure to properly install the batteries may result in an accident resulting in
death, serious injury and/or property damage. If you are uncertain about any
aspect of the assembly and adjustment of your bike, seek help from a qualified
mechanic or the OSET Customer Service Department.
14. Unpack charger from its box and read manual. CHECK THAT THE
VOLTAGE SWITCH IS SET CORRECTLY FOR YOUR COUNTRY (120 or
240v). Charge the batteries while thoroughly reading the complete owners
manual. (See charging Instructions on pages 26).
15. Compress and check each brake lever in turn. The lever should not
compress completely to the bar. Each individual brake should hold the bike
securely when you push the OSET against the brake. If your brake needs
adjustment, follow the instructions on page 23. Learning riders should be aware
which lever operates which brake.
16. For maximum battery life, always fully charge before operating your OSET for
the first time and never store with discharged batteries. (See page 26 for
charging instructions).
17. While your batteries are charging, please Read Your Owners Manual
completely.
Now your OSET is fully assembled, adjusted and checked. Once the
batteries are fully charged, your OSET will be ready to ride safely.
To Next Page
Loading...
