FRONT WHEEL REMOVAL AND INSTALLATION:
Please refer to the section on assembling your OSET bike (page 15) for
information on installing the front wheel, and reverse the instructions for
removal.
REAR WHEEL REMOVAL AND INSTALLATION:
1. Ensure power is switched off and
the key removed.
2. Lift the bike onto a block or stand
so the wheels are off the ground.
3. Loosen the axle bolts.
4. Loosen the chain adjustment
nuts to the point where the wheel
can be pushed forward, and the
chain slipped off to the right of the
sprockets.
5. Pull back on the wheel to remove
it.
To re-install the wheel reverse the above
procedures. Ensure the chain is correctly
adjusted and lubricated, the wheel is
aligned, and all nuts and bolts are tight.
To Next Page
Loading...
