9
Safety notes
Danger zones M and G
In accordance with IEC 60601-1 / UL 60601-1, the control unit is not suitable for use in potentially explosive
atmospheres or with potentially explosive mixtures of anaesthetic substances containing oxygen or nitrous oxide.
Control unit
The control unit is classed as "conventional equipment" (closed equipment without protection against the ingress of
water).
The OSM2 Program 4 is only designed to be used with the contra-angle handpieces WS-75 E/KM and
WI-75 E/KM approved by W&H. Use of other contra-angle handpieces may result in deviation from the indicated
torques and is under the user’s responsibility. The specified transmission ratios for the Programs
1 to 5 must always be considered.
Motor and foot control
The motor and foot control are approved for use in zone M (AP).
Please note that at low speeds, it is more difficult to determine that the motor is running.
Mains cable
Only connect to an earthed socket outlet.
Power failure
In the event of a power failure, if the OSM2 is switched off, or when alternating between programs, the last values set are
saved and re-activated on power-up.
To Next Page
Loading...