BLENDER IMPORTANT SAFEGUARDS
When using electrical appliances, the safety precautions the General
Important Safeguards section and the following safety precautions should
always be followed.
1. Read all instructions.
2.
Avoid contacting moving parts. Keep
hands and
utensils out of container
while blending to reduce the risk of severe injury to persons and/or
damage to the blender. If scraping, folding, etc. is necessary, turn the
blender “OFF” and use a rubber spatula only.
3. The use of attachments, including canning or ordinary jars, agitators or
processing assemblies, or sealing rings not recommended by the
manufacturer, can result in malfunction and cause injury to the user
and/or damage to the blender.
4. Blades are sharp. Handle carefully.
5. To reduce the risk of injury to persons, never place cutting blades on
base without jar properly attached.
6. Screw on container bottom firmly. Injury can result if moving blades
accidentally become exposed. If the container should turn when the
motor is switched “ON,” switch “OFF” immediately and tighten container
in threaded container bottom. Always hold container while processing.
7. Always operate blender with cover in place.
8. When blending hot liquids, remove the feeder cap from the two-piece
cover. Always begin processing hot liquids at the lowest speed setting
to prevent spillage from the center opening and possibly causing burns.
9. Do not blend hot liquids in “Mini-Blend” containers.
10.
Do not place blender jar or “Mini-Blend” containers in a conventional or
microwave oven.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
