42 43
Cleaning and maintenance
FittingLINK is a sealed device that requires minimum maintenance.
To ensure high levels of hygiene always disinfect FittingLINK before a programming
session begins.
To disinfect, wipe FittingLINK and the neck loop with a 70% alcohol / 30% water
solution. FittingLINK and the neck loop must never be washed or immersed in water or
other liquids.
The power supply, the charging cradle and the Bluetooth adapter must be kept free of
dirt and debris. These parts are to be cleaned with a soft dry cloth only.
When FittingLINK is not in use, turn it OFF and store it in the charging cradle in order for it
to be sufficiently charged and ready for the next fitting session.
To ensure personal safety and correct use you should familiarise yourself fully with the
following general warnings and the entire contents of this booklet before using your
FittingLINK. Consult your supplier's support function if you experience unexpected
operations or events with your FittingLINK.
Connection to external equipment
When using the USB cable always insert the cable into FittingLINK before connecting the
cable to other equipment.
The safe use of FittingLINK when connected to external equipment with a USB cable
is determined by the external signal source. When connected to external equipment
plugged into a wall outlet, this equipment must comply with IEC-62368 (or IEC-60065,
IEC-60950 until June 20, 2019) or equivalent safety standards.
Warnings
To Next Page
Loading...
Need help?
General
