POWER
10 11
Basic functions - first-time use
Insert the USB cable in the bottom of the charging cradle and the charger is ready for use.
Turning FittingLINK ON/OFF
Power on
Press the ON/OFF button on top of FittingLINK for approx. 2 seconds until you see a
green steady light from the top LED and a short red and blue flash from the front LED
indicators. The LED lights indicate that FittingLINK is powered on and you can release the
ON/OFF button.
If FittingLINK cannot power on, make sure it is charged.
If the top LED shows a red light instead of the green light the battery is running low
(steady red light) or very low (flashing red light) and FittingLINK should be charged.
Please refer to “See how to charge FittingLINK”.
Power off
Press and hold the ON/OFF button on top of FittingLINK for approx. 2 seconds until the
top LED indicator turns off.
To Next Page
Loading...
Need help?
General
