oticon FittingLINK WP-2 - Page 29

56
Description of symbols used in this booklet
Warnings
Text marked with a marking symbol must be read before using the product.
Manufacturer
The product is produced by the manufacturer whose name and address are stated next to the
symbol. Indicates the medical device manufacturer, as dened in EU Directives 90/385/EEC,
93/42/EEC and 98/79/EC.
CE mark
The product complies with Medical Device Directive 93/42/EEC.
Electronic waste (WEEE)
Recycle your hearing aids, accessories or batteries according to local
regulations or return them to your hearing care professional for disposal. Electronic equipment
covered by Directive 2012/19/EU on waste and
electrical equipment (WEEE).
Regulatory Compliance Mark (RCM)
The product complies with electrical safety, EMC and radio spectrum requirements for products
supplied to the Australian or New Zealand market.
Bluetooth logo
Registered trademark of Bluetooth SIG, Inc. where any use of such requires a license.
Description of additional symbols used on labels
Keep dry
Indicates a medical device that needs to be protected from moisture.
Caution symbol
Consult instructions for use for warnings and cautions.
Catalogue number
Indicates the manufacturer’s catalogue number so that the medical device
can be identied.
Serial number
Indicates the manufacturer’s serial number so that a specic medical
device can be identied.
Power supply outlet
Indicates the rate at which power is sent from the outlet to your electrical device.
Japan TELEC symbol
Indicates mark for certied radio equipment.
Singapore IMDA label
Indicates that the device complies with the standards and specication published by Info-
Communications Media Development Authority (IMDA) and is compatible with the public
telecommunication networks in Singapore and does not cause radio frequency interference to
other authorized radio-communication networks.
This symbol indicates that the product described in these instructions for use adheres to the
requirements for an applied part of Type B of EN 60601-1. The surface of the product was
specied as an applied part of Type B.
173877UK / 2019.03.22 173877UK / 2019.03.22