1
Installation Manual
TYPE 87
Table of content page
1. Chair lift assembly 3
2. Rail assembly 5
2.1 Assembling the rail 5
2.2 Charge-points 7
2.3 Installing the chair on the rail and testrun 8
2.4 Finishing the rail 10
3. Remote control assembly 11
4. Transmitters and receivers 12
4.1 Teaching the 2-channel remotes into a 2-channel receiver 12
4.2 Reverse logic up/down of 2-channel receiver. 12
4.3 Adjusting the dipswitches of the 1-channel transmitter and receiver 13
4.4 Types and type numbers 13
5. Programming the chairlift 14
5.1 Need to know before programming 14
5.2 Programming the chairlift 15
6. Completing the lift in case of a sliding rail 16
7. Completing the chair 17
8. Testing the chairlift 18
8.1 Sensitive edges 18
8.2 Safety switches/inputs 19
9 Locating and correcting malfunctions 20
9.1 Diagnostic display. 20
9.2 LED’s on the PCB 21
9.3 8888x error 21
9.4 Reset 21
9.5 Fuse safety-line 22
9.6 Bypass-connector 22
9.7 Interconnections on the PCB 22
9.8 Transformer/ on board charging-circuit 23
9.9 Dipswitches 23
To Next Page
Loading...
