Otto Bock C-Brace - Notes on Applying the Product

CAUTION
Incorrect alignment, assembly or adjustment
Risk of injury due to change in or loss of functionality
► Assembly, adjustment and maintenance operations may only be completed by qualified personnel.
► Observe the alignment, assembly and adjustment instructions.
CAUTION
Maximum load not checked
> Falling due to unexpected product behaviour because of changed damping behaviour.
► The Maximum Toe Load parameter must be checked after each adjustment or change to the dorsal stop.
NOTICE
Thermal overloading of the product
Damage due to improper thermal treatment
► Do not carry out any heat treatment at a temperature above 300°C (570°F).
► Prior to thermal treatment, remove all temperature-critical components (suchas plastic parts).
INFORMATION
The value selected for elevated flexion resistance (STP Flexion Damping Plus) cannot be lower than the value
selected for stance phase damping (STP Flexion Damping). Upon attempting to enter a lower value, this value is
automatically set to the value of the parameter STP Flexion Damping.
4.7 Notes on applying the product
CAUTION
Foreign objects between the leg and frame structure
Pressure points on the leg due to foreign objects at the contact points between the leg and frame structure.
► Smooth out wrinkles in the padding material and clothing.
► Check the leg for pressure points.
CAUTION
Using the product without shoes
> Falling due to altered swing phase triggering behaviour caused by incorrect heel height.
> Falling due to slipping when walking on smooth floor surfaces caused by the lack of a shoe profile on the foot
component.
► Only use the product with suitable shoes and with shoes that have the heel height established at the initial fit
ting.
CAUTION
Tying tall footwear (above the ankle)
Falling due to unexpected product behaviour caused by transmission of incorrect forefoot load data to the elec
tronics.
► By tying footwear too tight above the ankle, the spring element is bent even while it is not under load, which
can distort important sensor signals for the control unit.
► In case of footwear that extends above the ankle, ensure the laces are not tied to tight.
CAUTION
Incorrect fit of the frame structure
Falling/skin irritation due to insufficient support/hold by the frame structure.
► Take the frame structure off immediately and put it back on.
► Observe the instructions for applying and removing.
53C-Brace
Safety