Why am I not receiving notifications from my Overmax Dash Cameras when they detect movement?
If you are not receiving notifications when your Overmax Dash Cameras detect movement, ensure that push notifications are enabled both on your phone and within the application settings.
What to do if Overmax Dash Cameras microSD card is not recognized?
If your Overmax Dash Cameras device doesn't recognize the microSD card, verify the following: 1. Confirm that saving to the microSD card is enabled in the camera settings. 2. Ensure that your card's capacity does not exceed 128GB, as this is the maximum supported capacity. 3. Check that the card is not damaged and supports the FAT32 format.
How to restore factory settings on Overmax Dash Cameras?
To restore the factory settings on your Overmax Dash Cameras, either remove the camera from the device list in the app, or press and hold the reset button for 8 seconds until you hear a sound.
How can I change the router my Overmax Camspot 4.9 Pro Dash Cameras are connected to?
To change the router your Overmax Dash Cameras are connected to, remove the camera from the device list in the app, or press and hold the reset button for 8 seconds until you hear a sound, and then reconfigure the device.
What to do if Overmax Camspot 4.9 Pro Dash Cameras still cannot connect?
If your Overmax Dash Cameras still cannot connect, ensure that your phone and the camera are connected to the same network, that the DHCP protocol is enabled, and that the Wi-Fi signal strength is high. You may also try pressing and holding the reset button for 5 seconds to reset the device.
General| Brand | Overmax |
|---|---|
| Model | Camspot 4.9 Pro |
| Category | Dash Cameras |
| Language | English |
To Next Page
