OWC Mercury Elite Pro Assembly Manual & User Guide

OWC MERCURY ELITE PRO
DEVICE SETUP
5
4. To install the hard drive, carefully slide it into the black SATA connector inside the Mercury
Elite Pro, as shown below. You may need to move the red and brown LED cables to the
side, to make room for the drive. Make sure the drive is firmly seated before proceeding.
5. Using the four screws from the packet you removed from the inner chassis, fasten the
hard drive to the inner chassis. There are two screw holes on each side of the inner chassis,
circled below in red.
.

OWC Mercury Elite Pro Specifications

General

Number of storage drives supported	1
FireWire 800	Yes
Product color	Aluminum
Data transfer rate	5 Gbit/s
Cables included	AC, eSATA, FireWire, USB