49 GB/IE
Connecting the temperature station with the outdoor
sensor and the DCF radio signal:
After insert the batteries, the temperature station attempts to establish
a connection with the outdoor sensor. This process can take a few
minutes. The radio signal symbol
7
flashes. Once the
temperature
station has successfully connected to the outdoor sensor, the
radio signal symbol
7
stops flashing and the temperature is shown
in the LC display.
Note: If the temperature station does not receive the signal from
the outdoor sensor within 3 minutes, the temperature station auto-
matically starts with the reception of the radio time signal.
After successful reception of the outdoor sensor signal or after
3 minutes, the temperature station starts with the reception of the
radio time signal. This process can take up to 5 minutes and is
indicated in the LC display by the flashing
DCF symbol
11
.
A
fter successful reception of the DCF radio signal, the DCF symbol
11
is displayed continuously in the LC display.
Note: Do not move the temperature station while it is receiving the
signal. Otherwise this could interfere with reception. If synchronisation
is not possible when the temperature station is being first set up,
To Next Page
Loading...
Need help?
General