51 GB/IE
Mounting the temperature station and / or the outdoor
sensor on a wall:
Note: You will require an electric drill and a crosshead screwdriver
for this step.
CAUTION! DANGER TO LIFE, RISK OF INJURY AND
MATERIAL DAMAGE! Read the operating and safety instructions
for your drill carefully.
DANGER TO LIFE! Take care that you do
not hit electricity, gas or water lines when you drill into the wall.
If necessary, check with a pipe and cable detector before drilling.
Mark the position of the hole (ø approx. 6 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
35
,
43
into the drilled hole.
Using a crosshead screwdriver, screw the screw
36
,
44
into
the dowel.
Hang the temperature station or outdoor sensor by placing the
hanging slot
34
,
42
to the according screw.
To Next Page
Loading...
Need help?
General