2.Quick Start
2.Quick Start
General Inspection
After you get a new
digital clamp meter
, make a check on the instrument
according to the following steps:
1. Check whether there is any damage caused by transportation.
If it is found that the packaging carton or the foamed plastic protection
cushion has suffered serious damage, do not throw it away first till the
complete device and its accessories succeed in the electrical and
mechanical property tests.
2. Check the Accessories
The supplied accessories have been already described in the Appendix A:
Enclosure of this Manual. You can check whether there is any loss of
accessories with reference to this description. If it is found that there is any
accessory lost or damaged, please get in touch with our distributor
responsible for this service or our local offices.
3. Check the Complete Instrument
If it is found that there is damage to the appearance of the instrument, or
the instrument can not work normally, or fails in the performance test,
please get in touch with our distributor responsible for this business or our
local offices. If there is damage to the instrument caused by the
transportation, please keep the package. With the transportation
department or our distributor responsible for this business informed about
it, a repairing or replacement of the instrument will be arranged by us.
Install the Battery
The
digital clamp meter
is powered by a 3.7V (18650) battery.
Warning: To avoid false readings, which could lead to possible electric
shock or personal injury, replace the battery as soon as the low
battery indicator appears.
Before replacing the battery, turn off the meter, disconnect test
leads and any connectors from any circuit under test, remove
test leads from the input terminals. Use only the specified
To Next Page
Loading...
