IMPORTANT INFORMATION
RECOMMENDED FLUIDS AND GREASE
Quantity
Fluid Quality
Metric English
Fuel EN 590 (with national environmental and cold weather
standards)
ASTM D 975 No. 1 and No. 2
JIS KK 2204
- -
Engine oil
change incl.
filter
5w-30 dexos2 API SM/CF GM-LL-A025 /
B025 ACEA A3/B4
5.5 liters 5.8 quarts
Gear oil Fully Synthetic Dual Clutch Transmission Fluid - DCT 2.0 liters 2.1 quarts
Cooling system,
coolant mixture
GM Long-Life Coolant - Specification B040 1065/
Distilled water (30/70)
7.5 liters 7.9 quarts
Grease DIN 51502:KP2.5K-20
ISO 6743: ISO-L-XBCEB2.5
- -
Power trim and
tilt unit
ATF Dexron II 0.5-0.7 liters 0.52-0.73 quarts
Upper belt oil Fully Synthetic Transmission Fluid - ATF / Dexron HP 0.33 liters 0.34 quarts
Lower belt oil Fully Synthetic Transmission Fluid - ATF / Dexron HP 2 liters 2.1 quarts
NOTE! Only use fuels, lubricants etc. in accordance with Cimco Marine AB regulations. Otherwise the
manufacturer’s liability for defects will not apply!
Also refer to User’s manual and Service manual.
DIESEL FUELS
The composition of the fuels is vital for operation of the OXE outboard, its service life, and emissions. To meet
the performance specified and to run the boat cleanly and quietly, it is important that fuel as recommended in
table Recommended fluids and grease is used.
NOTE! The fuel must meet national and international standards.
OXE-diesel engines can be operated on local diesel fuel, not exceeding 350 ppm sulphur. Using such fuel will
increase the outboard’s emission levels and cause excessive wear and shorter lifetime.
NOTE! Large differences in composition occur in local fuel specifications. This can result in higher fuel
consumption, higher emissions and less power output.
IMPORTANT INFORMATION
To Next Page
Loading...