Method 1
1. Press the SEL key. The word “SEL” will show on the main display.
2. Enter the desired memory location (1-99). Press the CLEAR key. If the
location was active its number will flash, otherwise the numbers will clear
and a different location number can be entered.
3. To continue the clearing process, press the CLEAR key again then press
the ENTER key. Otherwise, to abort the clearing process, press the
ENTER key only.
Method 2
1. Press the SEL key. The word “SEL” will show on the main display.
2. Press the SEL key again, which causes the display to scroll through the
active memory locations. The memory location number will show in the
upper left corner of the display.
3. When the desired memory location shows, press the CLEAR key. The
location number will flash.
4. To continue the clearing process, press the CLEAR key again then press
the ENTER key. Otherwise, to abort the clearing process, press the
ENTER key only.
How to Clear all Memory Locations
To clear and deactivate (except memory location 1 which can be cleared but not
deactivated) all memory locations and their storage of readings and statistics,
press in sequence “٭” “9” “1” “9” “1” ENTER.
HOW TO TAKE MEASUREMENTS
Press the C/M key to change the mode of measurement between Continuous,
Regular and Scan.
Regular Mode
Select a memory location to store readings. Place the probe in contact with the
sample to be measured. The gage will beep, the measurement will be displayed,
and the reading will be saved into the statistics. If an unwanted measurement is
taken while in the Regular Mode, it can be cleared from the statistics by pressing
the CLEAR key. After the CLEAR key is pressed, the reading will be deleted and
the previous reading will be displayed.
Continuous Mode
To take measurements in Continuous Mode, place the probe on the part.
Instantaneous readings will be displayed until the probe is lifted off the part.
They will not be saved into the statistics unless the Capture Readings feature is
activated as described below.
How to Activate the Capture Readings feature
1. Place the gage in Continuous Mode.
2. Press the key sequence “٭” “4” “0” ENTER. The feature is now active and
readings will be saved into the statistics.
3. Place the probe on the sample to be measured. Press the ENTER key to
capture the reading.
Oxford Instruments Contact Measurement Page 11 of 24
233 USER GUIDE
The information in this document is private and confidential and must not be copied.
Oxford Instruments plc
To Next Page
Loading...