OXO Mistral 24 Instruction Manual

User Manual - Mistral 24 V1.2 05/2015 11/52
• 6 - Select a chase bank or scene master to store your pro-
gram. Tap the Page button to select a page(Page 1-4) to store
your scenes.
• 7 - Press a Flash button between 13-24 while holding down
the Record button. All LED will flash indicating the scenes have
been programmed into memory.
• 8 - You can continue programming or exit.
To exit Program mode, tap the Exit button while holding down
the Record button, the Record LED should go out.
EXAMPLE: Program a 16 steps chase with channel 1-16 at full in sequence into Flash button
15 of Page 1.
• 1 - Record enable.
• 2 - Push Master A & B to maximum position and Fade slider to top.
• 3 - Tap the Mode Select button to select 1-24 Single mode.
• 4 - Push Channel slider 1 to the top position, its LED light at full intensity.
• 5 - Tap the Record button to program this step into memory.
• 6 - Repeat steps 4 and 5 until you’ve programmed Channel sliders 1-16.
• 7 - Tap the Page button causing Page 1 LED lights.
• 8 - Tap the Flash button 15 while holding down the Record button, all LEDs will flash indi-
cating you’ve programmed the chase into memory.

OXO Mistral 24 Specifications

General

Brand	OXO
Model	Mistral 24
Category	Recording Equipment
Language	English