OXO Mistral 24 Instruction Manual

User Manual - Mistral 24 V1.2 05/2015 10/52
NOTE:
The second time you enter your new Record Code different from that of the first time, the LEDs
will not flash, which means you’ve failed to change the Record Code.
When you’ve entered a new Record Code the first time, and now you want to cancel the new
Record Code, you may press and hold down the Record and Exit buttons at a time to exit.
Program scene
• 1 - Record Enable.
• 2 - Select the 1-24 Single mode by tapping the Mode Se-
lect button. This will give you control of all 24 channels as you
program.
Be sure that Master A & B are both set at maximum.
(Master A is at its maximum in the fully up position , while aster
B is at its maximum in the fully down position.)
2
• 3 - Create a desired scene using Channel Sliders 1-24. At 0%
or DMX 0, these sliders should be at 0 position, and at 100% or
DMX 255, these sliders should be at 10 position.
• 4 - Once the scene is satisfactory, tap the Record button to
program the scene as a step into the memory.
• 5 - Repeat step 3 and step 4 until all desired steps have been
programmed into memory.
You may program up to 1000 steps into memory.

OXO Mistral 24 Specifications

General

Brand	OXO
Model	Mistral 24
Category	Recording Equipment
Language	English